Synchronous Electric Clock Motor-
High Torque - Suitable for dials up to 30" in diameter.
- Well made movement 50Hz (Cycles per second) 230/240v 3W
- Covered contacts and cable clips to comply with Safety Regulations.
- Hours and minute hands are included with each movement and the collets are supplied
separately so that you can make your own hands if the ones supplied are not suitable
- Centre fixing. 10 mm diameter Dial Hole required .
- Extension hand setting rod supplied
- The ideal movement for large indoor clocks.
- Can be used in outdoor clocks if the case and glass have been weatherproofed and
sealed
- TT435 Spindle length 35mm
Motor includes hands shown pictured below.
Hands suitable for Dial of 30" diameter -
Collets supplied separately. For fitment of your own hands if required
Minute hand centre hole to tip 14.5" - width 1.5".
Hour hand centre hole to tip 9" long - width 1.625"
£126.35 UK Only
inclusive of shipping to UK Mainland address.
Synchronous Electric Clock Motor -
Standard
- Well made movement 50Hz (Cycles per second) 230/240v 3W
- Covered contacts and cable clips to comply with Safety Regulations.
- Hour and minute hand fittings are the same as the Hechinger Standard Quartz Movements.
The centre seconds hand is a screw on fit (see H332 and H333).
- Centre fixing. 10 mm diameter Dial Hole required. Integral hanging bracket
Overall height 100mm excluding the hanger. Diameter 65mm and Depth 31mm.
TT346 15mm Spindle length.
£44:35 UK Only
inclusive of shipping to UK Mainland address.
Clock Motors, Mains Electric, 240v a.c. 50Hz
both Standard and High Torque types.
Clock Motors, Mains Electric, 240v a.c. 50Hz
both Standard and High Torque types.
Electrical Shock Hazard!!!
Risk of potentially fatal shock from these units. Be sure you understand what you are doing when you connect these units to the electrical supply
Electrical Shock Hazard!!!
Risk of potentially fatal shock from these units. Be sure you understand what you are doing when you connect these units to the electrical supply.
Large selection of Clock Hands are available for Standard movement but read text carefully when making a selection, especially for the centre seconds hand which has to be a screw on type
Either unit can be supplied in bulk quantities at discounted rate dependent on type
and how many.
Movements are suitable for use in Europe, Most of Africa, Most of Arabia, Most of Asia, Australia and New Zealand. If in any doubt please ask for assistance and we will be pleased to advise.